I bought six 108 watt tri color light strips and one 18 watt tri color single strip, intending to replace and transform them into a single low brightness 18 watt (single white light 9 watts) or single high brightness (54 watt white light), which can mix (low+high) 63 watt white light - the goal has been achieved, very good! Double open single control switch, yellow and white light fully open up to 18 watts+108 watts, first level white light 9 watts+54 watts, very cost-effective.

The original light strip was not completely broken, and after repair, it was prepared to continue using it for a period of time, so there was a comparison!

Compared with the original light strip, the original (old) light strip without lens is simply a direct LED diode light bead, and the light is strongest vertically below the ceiling light! Even strong enough to be a bit dazzling. The newly purchased light strip has a lens, and I found that the difference compared to the old light bead is that the illumination at a 45 degree angle (and towards the top) is much stronger, while the illumination intensity at the vertical bottom is not as strong as the old light bead. This change is very important—— The dark areas on the ceiling have become much brighter, and overall the lighting brightness in all directions has become more uniform. The scattering effect of the lens is excellent!

The test results can be seen in the photo. The new product can be activated when the old light bead reaches its end of life. Currently, both the old and new light strips are packed in the same box!

A small accident occurred. During the installation of the 18 watt single light strip on the ceiling, I accidentally dropped it and broke a magnet piece. Use tweezers to reinstall it and apply transparent tape without any worries.

The effects of using a single 18 watt light strip (actual 9-watt white light) and a single 108 watt light strip (actual 54 watt white light) are shown in the last two photos. Due to the optimization of phone brightness and darkness, the actual visual brightness effect is significantly different, and the two main effects of power saving and full brightness have achieved the expected results.