① Open the door cover, install the rotor and test tube, and ensure that the test capacity in the centrifuge tube is not greater than 90% of the maximum capacity. Place them symmetrically in the rotor body, close the door cover, turn on the power, and turn on the power switch Firstly, add the materials to be separated into the centrifuge tubes equipped with this machine, insert them into the centrifuge head holes respectively, and ensure that the mass of the materials added to each centrifuge tube is basically equal. Close the cover plate, select the speed, use ▲▼ to select the speed you need, then press the working time button, use ▲▼ to select the time you need, and then press the run button. At this time, the centrifuge enters the working state. When the set working time is reached, an alarm will automatically sound. To check the centrifugal force, press the centrifugal force button. 3. Press the operation switch, and the whole machine will start running. If you need to stop halfway, please press the stop button. The machine will automatically shut down after the set time. At this time, the buzzer will sound. After the rotor stops steadily, you can open the back cover, take out the sample, and turn off the power switch after use.

The high-speed centrifuge has been upgraded with high efficiency, low loss, and stable operation. The knob style adjustment can separately control the timing and centrifugal speed, making it convenient for efficiency. 800D (with timing) control panel>Rubber pad high base back power socket